Sedaconda ACD‑S is a single-use device (replaced every 24 hours or earlier when needed). The device can be inserted into either the breathing circuit of a ventilator between the endotracheal tube and Y piece, replacing the heat and moisture exchanger (standard placement) or in the inspiratory port of the ventilator (alternative placement). Liquid sedative is injected through the anaesthetic agent line, into a porous rod in the Sedaconda ACD‑S device where the sedative is vaporised. The vaporised sedative is then inhaled by the patient with the inspiration flow from the ventilator. With continued breathing, most of the sedative agent that has not been absorbed by the lungs is exhaled and adsorbed by an active carbon filter in the device. On further inhalation, the sedative is desorbed from the filter and transported back to the lungs, reducing the amount of sedative agent wasted. The Sedaconda ACD‑S device also contains a bacterial and viral filter and a gas analyser port. This port is used to measure the exhalated sedative concentration in minimal alveolar concentration, a relative measure of the level of anaesthesia; or end-tidal concentration. Side stream or mainstream gas monitors, which can measure concentrations of carbon dioxide and anaesthetic gases, must be used to continually monitor sedation. These will need to be purchased separately if not already available. Sedaconda ACD‑S is also recommended to be used with a gas scavenging system. This can be either by a passive system like the manufacturer's FlurAbsorb and FlurAbsorb‑S products, or by an active scavenging system. This is usually built into the hospital system to capture volatile anaesthetics in operating theatres.